Lorex L114V251 Manual de instrucciones descargar pdf (Pagina 31)

23

Using the Setup Menu

Screen

Use the Screen menu to set resolutions, turn

the channel border on/off, adjust the main

display position, and set the dwell time for Auto

Sequence Mode..

Figure 14.0 Screen menu

To configure screen settings:

1. From the Setup Menu, select Screen and

press

. The Screen menu opens.

2. Select Border and press  to select

On/Off. If On, a white border appears in

Quad mode dividing the quadrants of the

main display screen.

3. Select Video Adjustment and press .

The menu disappears. Press

 to

adjust the vertical and horizontal position

of the main display.

4. Select Auto Switching and press  to

set the dwell time for Auto Sequence

mode from 1~10 seconds or Off. The

higher the time, the longer the single

channel will remain on-screen during Auto

Sequence mode.

5. Select Resolution and press  to set

the display resolution at 640x480,

800x600, 1024x768 (default), or

1280x1024.

6. Press until the Exit menu appears.

Select Save & Exit and press to

save your settings.

Audio

Use the Audio menu to enable/disable audio

recording, change audio input/output volume,

and enable/disable mute.

Figure 15.0 Audio menu

To configure audio settings:

1. From the Setup Menu, select Audio and

press

. The Audio menu opens.

2. Select Record and press  to turn

audio recording On/Off.

Note: If audio recording is enabled, you

must connect line-in audio (RCA) to the

Audio-In port on the rear panel of the

system.

3. Select Mute and press  to Mute On/

Off. If off, all audio on the system will be

disabled (input and output).

4. Select Input Volume and press  to

increase/decrease the slider.

5. Select Output Volume and press  to

increase/decrease the slider.

6. Press until the Exit menu appears.

Select Save & Exit and press to

save your settings.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Comentarios a estos manuales

Sin comentarios