Lorex L208D251 Manual de instrucciones descargar pdf (Pagina 32)

System Setup Controls

32

EN

RS-485 SUBMENU

The information in the RS-485 submenu allows

users to configure the settings for an RS-485

Device.

NOTE: The configuration settings for this

section would be provided with the

documentation included with the RS-485

device.

• BAUDRATE: Set the Data

Transmission (Baud rate) to1200,

1800, 2400, 4800, 9600, 14400,

19200, 36400, 57600 or 115200 bps.

• DATA BIT: Set the Data Transmission

Bit to 7 or 8.

• PARITY BIT: Set the Data

Transmission Error Check Bit to odd,

even or none.

• STOP BIT: Set the Data Transmission

Stop Bit to 1 or 2.

PAN/TILT DEVICE SUBMENU

The information in the PAN/TILT Device

submenu allows users to configure the settings

for a PTZ Camera.

PAN/TILT DEVICE SUBMENU

NOTE: The configuration settings for this

section would be provided with the

documentation included with the PTZ Camera.

• CHANNEL: Select the Channel where

PTZ camera is connected.

• ID: Assign the specific ID of the PTZ

camera.

• MODEL: Select the model of PTZ

camera.

• PAN/TILT TEST: Test PTZ Camera.

F/W UPGRADE

The DVR supports upgrading the Firmware

through a USB Memory Stick.

If a USB Memory Stick is not detected by the

system, a failure message will appear:

If a USB Memory Stick is detected with valid

Firmware files, the following screen will appear:

Press the PLAY Button to update the firmware,

or press the STOP Button to cancel.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 227 228

Comentarios a estos manuales

Sin comentarios